Reference Guide

736 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
Related
Commands
match ipv6 route-source
c e s
Configure a filter which matches based on the routes advertised in the IPv6 prefix lists.
Syntax
match ipv6 route-source prefix-list prefix-list-name
To delete a match, use the
no match ipv6 route-source prefix-list prefix-list-name command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
route-map
c e s
Designate a IPv6 route map name and enter the ROUTE-MAP mode.
Syntax
route-map map-name
To delete a route map, use the
no route-map map-name command.
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
match ipv6 address Redistribute routes that match an IP address.
match ipv6 route-source Redistribute routes that match routes advertised by other routers.
prefix-list prefix-list-name Enter the keywords prefix-list followed by the name of
configured prefix list, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are
up to 16 characters long.
Version 7.4.1.0 Introduced support on the E-Series TeraScale
match ipv6 address Redistribute routes that match an IP address.
match ipv6 next-hop Redistribute routes that match the next-hop IP address.
map-name
Enter a text string to name the route map, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale