Reference Guide

726 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
remark 10 Remark for Entry # 10
seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
seq 20 permit udp any any gt 100 count
!FTOS(config-ipv6-acl)#
Usage
Information
As shown in the example above, the same sequence number is used for the remark and an
ACL rule. The remark will precede the rule in the running-configuration because it is
assumed that the remark is for that rule or that group of rules that follow the remark. You can
configure up to 4294967290 remarks in a given ACL.
Related
Commands
resequence access-list
c e s
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum Step-to-Increment}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new
sequence number to entries of an existing access-list.
Related
Commands
show config Display the current ACL configuration.
ipv4 | ipv6 | mac
Enter the keyword ipv4, ipv6 or mac to identify the access list type to
resequence.
access-list-name Enter the name of a configured IP access list, up to 140 characters.
Increased name string to accept up to 140 characters. Prior to 7.8.1.0,
names are up to 16 characters long.
StartingSeqNum
Enter the starting sequence number to resequence.
Range: 0 to 4294967290
Step-to-Increment
Enter the step to increment the sequence number.
Range: 1 to 4294967290
Version 8.4.2.0 Introduced on the S-Series
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Introduced on the C-Series
Version 7.4.1.0 Introduced on the E-Series TeraScale
resequence prefix-list ipv6 Resequence a prefix list