Reference Guide

IPv4 Routing | 699
c e s
View a table summarizing the IP routes in the switch.
Syntax
show ip route summary
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS>show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
FTOS>
Related
Commands
show ip traffic
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Table 23-15. show ip route summary Column Headings
Column Heading
Description
Route Source Identifies how the route is configured in FTOS.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active Routes Identifies the back-up routes when a route is learned by two different
protocols. If the best route or active route goes down, the non-active route
will become the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised,
then information on those routes is displayed.
Total 1388 active... Displays the number of active and non-active routes and the memory usage
of those routes.
If there are no routes configured in the FTOS, this line does not appear.
show ip route Display information about the routes found in switch.