Reference Guide

678 | IPv4 Routing
www.dell.com | support.dell.com
management route
c e
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6-address}/mask {forwarding-router-address |
managementethernet}
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static
route (or a protocol route) is preferred over the Management Static route. Also, Management
static routes and the Management Connected prefix are not reflected in the hardware routing
tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This
command manages both tables.
Related
Commands
show arp
{ipv4-address | ipv6-address}/mask Enter an IPv4 address (A.B.C.D) or IPv6 address
(X:X:X:X::X), followed by the prefix-length for the IP
address of the management interface.
forwarding-router-address
Enter an IPv4 or IPv6 address of a forwarding router.
managementethernet Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Version 8.4.1.0 Added support for IPv6 management routes.
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the
Primary or Standby RPM).
duplex (Management) Set the mode of the Management interface.
speed (Management interface) Set the speed for the Management interface.