Reference Guide

IPv4 Routing | 667
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
ip max-frag-count
c e s
Set the maximum number of fragments allowed in one packet for packet re-assembly.
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, enter no ip max-frag-count.
Parameters
Defaults
No limit is set on number of fragments allowed.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for
re-assembly low.
ip mtu
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
count
Enter a number for the number of fragments allowed for re-assembly.
Range: 2 to 256
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series