Reference Guide

610 | Interfaces
www.dell.com | support.dell.com
GigabitEthernet 8/10 YES up up
GigabitEthernet 8/11 YES up up
FTOS>
Related
Commands
show interfaces linecard
c e
Display information on all interfaces on a specific line card.
Syntax
show interfaces linecard slot-number
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
The following figure shows a line card that has an XFP interface. The type, medium,
wavelength, and receive power details are displayed. When a device that is not certified by
Dell Force10 is inserted, it might work, but its details might not be readable by FTOS and not
displayed here.
Example
FTOS#show interfaces linecard 0
TenGigabitEthernet 0/0 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:51:b2:d4
Current address is 00:01:e8:51:b2:d4
Pluggable media present, XFP type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850.00nm
XFP receive power reading is -2.3538
Interface index is 33883138
Internet address is not set
Table 22-6. show interfaces description Command Example Fields
Field Description
Interface Displays type of interface and associated slot and port number.
OK? Indicates if the hardware is functioning properly.
Status States whether the interface is enabled (up) or disabled (administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
Description Displays the description (if any) manually configured for the interface.
show interfaces Display information on a specific physical interface or virtual interface.
slot-number
Enter a number for the line card slot.
C-Series Range: 0-7 for C300; 0–3 for C150
E-Series Range: 0 to 13 on the E1200/1200i, 0 to 6 on the E600/600i, 0 to 5
on the E300
Version 8.1.1.2 Introduced support on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series