Reference Guide

Interfaces | 601
Note: After the counters are cleared, the line-rate continues to increase until it
reaches the maximum line rate. When the maximum line rate is reached, there will be
no change in the line-rate.
Example
FTOS#show interfaces
TenGigabitEthernet 2/0 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:01:e8:8b:3d:e7
Current address is 00:01:e8:8b:3d:e7
Pluggable media present, Media type is unknown
Wavelength unknown
Interface index is 100992002
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3d17h53m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 3d17h51m
Table 22-5. Lines in show interfaces Command Example
Line Description
TenGigabitEthernet 2/0... Displays the interface’s type, slot/port, and administrative and line
protocol status.
Hardware is... Displays the interface’s hardware information and its assigned MAC
address.
Interface index... Displays the interface index number used by SNMP to identify the
interface.
Internet address... States whether an IP address is assigned to the interface. If one is, that
address is displayed.
MTU 1554... Displays link and IP MTU information.
If the chassis is in Jumbo mode, this number can range from 576 to
9252.
LineSpeed Displays the interface’s line speed.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing... Displays the time when the show interfaces counters where cleared.
Queuing strategy... States the packet queuing strategy. FIFO means first in first out.