Reference Guide

Internet Group Management Protocol (IGMP) | 565
To delete a specific multicast router interface, use the no igmp snooping mrouter interface
interface
command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
Usage
Information
FTOS provides the capability of statically configuring interface to which a multicast router is
attached. To configure a static connection to the multicast router, enter the
ip igmp snooping
mrouter interface
command in the VLAN context. The interface to the router must be a part of
the VLAN where you are entering the command.
ip igmp snooping querier
c e s
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, enter no ip igmp snooping querier
command.
Defaults
Not configured
Command Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
interface interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series