Reference Guide

Internet Group Management Protocol (IGMP) | 555
ip igmp query-max-resp-time
c e s
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time
seconds
To return to the default values, enter
no ip igmp query-max-resp-time.
Parameters
Defaults
10 seconds
Command Modes
INTERFACE
Command
History
ip igmp ssm-map
c e s
Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
Syntax
ip igmp ssm-map
std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G)
states using the command
ip igmp ssm-map std-access-list source-address command.
Parameters
Command Modes
CONFIGURATION
Command
History
seconds Enter the number of seconds for the maximum response time.
Default: 10 seconds
Range: 1 to 25
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to
act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to
act as an IGMP Proxy Querier.
E-Series legacy command
std-access-list
Specify the standard IP access list that contains the mapping rules for
multicast groups.
source-address
Specify the multicast source address to which the groups are mapped.
Version 8.3.7.0 Introduced on S4810