Reference Guide

GARP VLAN Registration (GVRP) | 529
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the
no garp timers {join | leave | leave-all} command.
Parameters
Defaults
Default as above
Command Modes
CONFIGURATION-GVRP
Command
History
Usage
Information
Join Timer—Join messages announce the willingness to register some attributes with other
participants. Each GARP application entity sends a Join message twice, for reliability, and
uses a join timer to set the sending interval.
Leave Timer—Leave announces the willingness to de-register with other participants.
Together with the Join, Leave messages help GARP participants complete attribute
reregistration and de-registration. Leave Timer starts upon receipt of a leave message sent for
de-registering some attribute information. If a join message is not received before the leave
time expires, the GARP application entity removes the attribute information as requested.
Leave All Timer—The Leave All Timer starts when a GARP application entity starts. When
this timer expires, the entity sends a leave-all message so that other entities can re-register
their attribute information. Then, the leave-all time begins again.
Related
Commands
gvrp enable
c e s
Enable GVRP on physical interfaces and LAGs.
join
Enter the keyword join followed by the number of milliseconds to configure the join
time.
Range: 100 to 147483647 milliseconds
Default: 200 milliseconds
Note: Designate the milliseconds in multiples of 100
leave
Enter the keyword leave followed by the number of milliseconds to configure the leave
time.
Range: 100 to 2147483647 milliseconds
Default: 600 milliseconds
Note: Designate the milliseconds in multiples of 100
leave-all
Enter the keyword leave-all followed by the number of milliseconds to configure the
leave-all time.
Range: 100 to 2147483647 milliseconds
Default: 1000 milliseconds
Note: Designate the milliseconds in multiples of 100
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C, E, and S-Series
show garp timers Display the current GARP times