Reference Guide

Force10 Resilient Ring Protocol (FRRP) | 523
Usage
Information
This command places you into the Resilient Ring Protocol. After executing this command,
the command line prompt changes to conf-frrp.
show frrp
c e
Display the Resilient Ring Protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
(show frrp
summary)
FTOS#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
FTOS#
Example
(show frrp
ring-id)
FTOS#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : GigabitEthernet 0/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
FTOS#
Example
(show frrp ring-id
summary)
FTOS#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------------------------
2 Up Master 2 11-20, 25, 27-30
FTOS#
Related
Commands
ring-id
Enter the ring identification number.
Range: 1 to 255
summary
(OPTIONAL) Enter the keyword summary to view just a
summarized version of the Ring configuration.
Version 8.3.7.0 Introduced for the S4810
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
protocol frrp Enter the Resilient Ring Protocol and designate a ring identification