Reference Guide

508 | FIP Snooping
www.dell.com | support.dell.com
Parameters
Defaults
0x0EFC00
Command Mode
CONFIGURATION
VLAN INTERFACE
Command
History
fip-snooping port-mode fcoe-trusted
Configure the port for bridge-to-bridge links.
Syntax
fip-snooping port-mode fcoe-trusted
To remove the bridge-to-bridge link configuration from the port, use the no fip-snooping port-mode
fcoe-trusted command.
Command Modes
INTERFACE
Command
History
Usage
Information
The maximum number of FCoE VLANs supported on the switch is eight.
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf command.
Command Modes
INTERFACE
Command
History
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
fc-map-value
Enter the FC-MAP value used by FIP snooping.
The range is from 0EFC00 to 0EFCFF.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module