Reference Guide

502 | Equal Cost Multi-Path
www.dell.com | support.dell.com
Command
History
Usage
Information
You must save the new ECMP settings to the startup-config (write-mem) then reload the
system for the new settings to take effect.
Related
Commands
link-bundle-monitor enable
Provides a mechanism to enable monitoring of traffic distribution on an ECMP link bundle.
Syntax
link-bundle-monitor enable
To exit from ecmp group mode, use the exit command.
Command Modes
ECMP-GROUP
PORT-CHANNEL INTERFACE
Command
History
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution will begin being
monitored on an ECMP link bundle.
Syntax
link-bundle-distribution trigger-threshold
[percent]
To exit from ecmp group mode, use the
exit command.
Parameters
Command Modes
EXEC Privilege
Command
History
show config
Display the ECMP configuration.
Version 8.3.10.0 Introduced on S4810
show ip cam stack-unit Display content-addressable memory (CAM) entries for an S-Series
switch.
Version 8.3.10.0 Introduced on S4810
percent
Indicate the threshold value when traffic distribution will start being
monitored on an ECMP link bundle.
Range: 1 to 90%
Default: 60%
Version 8.3.10.0 Introduced on S4810