Reference Guide

406 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Defaults
Not configured
Command Modes
CONFIGURATION (conf-ext-community-list)
Command
History
ip extcommunity-list
c e s
Use this feature to enter the Extended Community-list mode.
Syntax
ip extcommunity-list word
To exit from this mode, use the exit command.
Parameters
Defaults
No defaults values or behavior
Command Modes
CONFIGURATION (conf-ext-community-list)
Usage
Information
This new mode will change the prompt. Refer to the example below.
Example
FTOS(conf)#ip extcommunity-list test
FTOS(conf-ext-community-list)#
Command
History
match extcommunity
c e s
Use this feature to match an extended community in the Route Map mode.
Syntax
match extcommunity {extended community list name}
To change the match, use the
no match extcommunity {extended community list name}
command.
Parameters
Defaults
No defaults values or behavior
Command Modes
ROUTE MAP (config-route-map)
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
word
Enter a community list name (maximum 16 characters).
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
extended community list name
Enter the name of the extended community list.