Reference Guide

File Management |37
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION
Command
History
Usage
Information
In this streamline copy command, the source image is copied to the primary RPM and then, if
specified, to the standby RPM. After the copy is complete, the new image file path on each
RPM is automatically configured as the primary image path for the next boot. The current
system image (the one from which the RPM booted) is automatically configured as the
secondary image path.
FTOS supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP.
copy running-config startup-config
c e
Copy running configuration to the startup configuration.
Syntax
copy running-config startup-config {duplicate}
Command Modes
EXEC Privilege
Command
History
Usage
Information
This command is useful for quickly making a changed configuration on one chassis available
on external flash in order to move it to another chassis.
source-url
Enter the source file in url format. The source file is a valid Dell Force10
release image. Image validation is automatic.
target-url Enter the local target file in url format.
boot-image
Enter the keyword boot-image to designate this copy command as a
streamline update.
synchronize-rpm
Enter the keyword synchronize-rpm to copy the new image file to the peer
RPM.
external
Enter the keyword external to designate the target device on the peer RPM
as external flash (instead of the default internal flash).
Default: Internal Flash
Version 8.4.1.0 Added IPv6 addressing support for FTP, TFTP, and SCP.
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced
Note: The keywords boot-image, synchronize-rpm, and external can be used on the
Primary RPM only.
Version 7.5.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced