Reference Guide

350 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
With FTOS version 8.3.1.0 and later, the redistribute command can be used to advertise the
IGP cost as the MED
on redistributed routes. When the route-map is set with metric-type internal
and applied outbound to an EBGP peer/peer-group, the advertised routes corresponding to
those peer/peer-group will have IGP cost set as MED.
When you enter redistribute isis
process-id command without any other parameters, FTOS
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. This
feature is not supported by an RFC.
Command
History
router bgp
c e s
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Example
FTOS(conf)#router bgp 3
process-id Enter the number of the OSPF process.
Range: 1 to 65535
match external {1 | 2} (OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPF internal routes only.
route-map map-name (OPTIONAL) Enter the keywords route-map followed by the name
of a configured Route map.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced ability to substitute IGP cost for MED when a peer/
peer-group outbound route-map is set as internal.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
as-number
Enter the AS number.
Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte) or
0.1-65535.65535 (Dotted format)