Reference Guide

34 | File Management
www.dell.com | support.dell.com
Parameters
Command Modes
CONFIGURATION
Usage
Information
Saving the address to the startup configuration file preserves the address in NVRAM in case
the startup configuration file is deleted.
Command
History
Related
Commands
cd
c e s
Change to a different working directory.
Syntax
cd directory
Parameters
Command Modes
EXEC Privilege
Command
History
change bootflash-image
c e
Change boot flash image from which to boot.
Syntax
change bootflash-image {cp | linecard linecard-slot | rp}
Parameters
ip-address
Enter an IP address in dotted decimal format.
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
change bootflash-image Change the primary, secondary, or default boot image configuration.
directory
(OPTONAL) Enter one of the following:
• flash: (internal Flash) or any sub-directory
• slot0: (external Flash) or any sub-directory (C-Series and E-Series only)
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
cp
Enter the keyword cp to change the bootflash image on the Control
Processor on the RPM.
linecard linecard-slot Enter the keyword linecard followed by the slot number to change the
bootflash image on a specific line card.
C-Series Range: 0-7
E-Series Range: 0 to 13 on the E1200; 0 on 6 on the E600, and 0 to 5
on the E300.
rp
Enter the keyword rp to change the bootflash image on the RPM
Route Processor.