Reference Guide

242 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Use the no seq sequence-number command syntax if you know the filters
sequence number or
Use the
no permit {any | host mac-address | mac-source-address
mac-source-address-mask
} {any | mac-destination-address
mac-destination-address-mask
} command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-EXTENDED
any Enter the keyword any to forward all packets.
host
Enter the keyword host followed by a MAC address to
forward packets with that host address.
mac-source-address
Enter the source MAC address in nn:nn:nn:nn:nn:nn
format.
mac-source-address-mask
Specify which bits in the MAC address must be
matched.
The MAC ACL supports an inverse mask, therefore, a
mask of ff:ff:ff:ff:ff:ff allows entries that do not match
and a mask of 00:00:00:00:00:00 only allows entries that
match exactly.
mac-destination-address
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
mac-destination-address-mask Specify which bits in the MAC address must be
matched.
The MAC ACL supports an inverse mask, therefore, a
mask of ff:ff:ff:ff:ff:ff allows entries that do not match
and a mask of 00:00:00:00:00:00 only allows entries that
match exactly.
ethertype operator
(OPTIONAL) To filter based on protocol type, enter one
of the following Ethertypes:
ev2 - is the Ethernet II frame format.
llc - is the IEEE 802.3 frame format.
snap - is the IEEE 802.3 SNAP frame format.
count
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to
log the packets.
monitor
(OPTIONAL) Enter the keyword monitor when the rule
is describing the traffic that you want to monitor and the
ACL in which you are creating the rule will be applied to
the monitored interface. For details, refer to the section
“Flow-based Monitoring” in the Port Monitoring chapter
of the FTOS Configuration Guide.