Reference Guide

184 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command
History
Example
FTOS(config-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(config-ext-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended)
and do not have mode-specific options. When an access-list (ACL) is created without any rule
and then applied to an interface, ACL behavior reflects an implicit permit.
c and s platforms support Ingress IP ACLs only.
The following commands allow you to clear, display, and assign IP ACL configurations.
• access-class
• clear counters ip access-group
• ip access-group
• show ip access-lists
• show ip accounting access-list
access-class
c e s
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name
Parameters
Defaults
Not configured.
Command Modes
LINE
Command
History
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced
Note: Refer also to Commands Common to all ACL Types.
access-list-name
Enter the name of a configured Standard ACL, up to 140 characters.
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale