Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1501
clear counters vrrp ipv6
e c s
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf instance]
Parameters
Command Modes
EXEC Privilege
Command
History
debug vrrp ipv6
e c s
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
Command Modes
EXEC Privilege
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group.
Range: 1 to 255
vrf
instance (OPTIONAL) E-Series only: Enter the name of a VRF instance (32 characters
maximum) to clear the counters of all IPv6 VRRP groups in the specified VRF.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series. Support was
added for IPv6 VRRP groups in non-default VRF instances.
Version 8.3.10.0 Introduced on S4810
Version 8.3.2.0 Introduced on E-Series TeraScale
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed by a
number:
E-Series Range: 1 to 255 for TeraScale
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by the VLAN ID.
The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all
Enter the keyword all to enable debugging of all VRRP groups.
bfd
Enter the keyword bfd to enable debugging of all VFFP BFD interactions
database
Enter the keyword database to display changes related to group, prefix, and
interface entries in the VRRP table.
packets
Enter the keyword packets to enable debugging of VRRP control packets.
state
Enter the keyword state to enable debugging of VRRP state changes.
timer
Enter the keyword timer to enable debugging of the VRRP timer.