Reference Guide

Uplink Failure Detection (UFD) | 1473
Related
Commands
Example
FTOS(conf)#uplink-state-group 16
FTOS(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state group Admin state to up: Group 16
upstream
s S50 only
Assign a port or port-channel to the uplink-state group as an upstream interface.
Syntax
upstream interface
Parameters
Defaults
None
Command Modes
UPLINK-STATE-GROUP
Command
History
Usage
Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Each interface assigned to an
uplink-state group must be configured as either an upstream or downstream interface, but not
both.
You can assign individual member ports of a port channel to the group. An uplink-state group
can contain either the member ports of a port channel or the port channel itself, but not both.
To delete an uplink-state group, enter the no upstream interface command.
show running-config
uplink-state-group
Display the current configuration of one or more uplink-state groups.
show uplink-state-group Display status information on a specified uplink-state group or all
groups.
interface Enter one of the following interface types:
• Fast Ethernet: fastethernet {slot/port | slot/port-range}
• 1-Gigabit Ethernet: gigabitethernet {slot/port | slot/port-range}
• 10-Gigabit Ethernet: tengigabitethernet {slot/port | slot/port-range}
• 40-Gigabit Ethernet: fortyGigE {slot/port | slot/port-range}
• Port channel: port-channel {1-512 | port-channel-range}
Where port-range and port-channel-range specify a range of ports
separated by a dash (-) and/or individual ports/port channels in any order;
for example:
gigabitethernet 1/1-2,5,9,11-12
port-channel 1-3,5
A comma is required to separate each port and port-range entry.
Version 8.3.12.0 Introduced on S4810
Version 8.4.2.3 Introduced on the S-Series S50.