Reference Guide

S4810 u-Boot | 1461

S4810 u-Boot

Overview

All commands in this chapter are in u-Boot. These commands are supported on the Dell

Force10 platform only.

To access this mode, hit any key when the following line appears on the console during a

system boot:

Hit any key to stop autoboot:

You enter u-Boot immediately, as indicated by the => prompt.

Commands

• printenv

• reset

• save

• setenv

printenv

Display the current system boot variable and other system settings.

Syntax

printenv

Command Modes

uBoot

Command

History

Note: This chapter discusses only a few commands available in uBoot. The

commands included here are those that are comparable to those found in the Boot

User mode on other S-Series systems.

Note: You cannot use the Tab key to complete commands in this mode.

Version 8.3.7.0 Introduced on the S4810.