Reference Guide

1454 | VLAN Stacking
www.dell.com | support.dell.com
Parameters
Defaults
N/A
Command Mode
CONFIGURATION
Command
History
Usage
Information
vlan-stack access
c e s
Specify a Layer 2 port or port channel as an access port to the Stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, enter no vlan-stack access.
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
Prior to enabling this command, you must enter the switchport command to place the interface
in Layer 2 mode.
To remove the access port designation, the port must be removed (using the
no member
interface command) from all Stackable VLAN enabled VLANs.
unit-id
Enter the stack unit ID.
stack-group-id
Enter the stack group ID. Range is 0 to 16.
[no]
Use no stack-unit unit-id stack-group stack-id to remove the current
stack group configuration.
Version 8.3.10.2 Introduced on S4810
Warning: The following message is displayed to confirm the command:
All non-default configurations on the related member ports
ports (<ports listed here>) will be removed. Do you want to
continue (y/n)?
If “y” is entered, all non-default configurations on any member ports of the current stack group
will be removed when the unit is rebooted.
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.6.1.0 Support added for C-Series and S-Series
E-Series original Command