Reference Guide

Simple Network Management Protocol and Syslog | 1377
Defaults
As defined above
Command Modes
CONFIGURATION
Command
History
Usage
Information
The following example specifies the group named harig as a version 3 user requiring both
authentication and encryption and read access limited to the read named
rview.
Example
FTOS#conf
FTOS(conf)# snmp-server group harig 3 priv read rview
FTOS#
Related
Commands
snmp-server host
c e s z
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address [traps | informs] [version 1 | 2c | 3] [auth | no auth |
priv] [community-string] [udp-port port-number] [notification-type]
To remove the SNMP host, use the
no snmp-server host ip-address [traps | informs] [version 1 |
2c | 3] [auth | noauth | priv] [community-string] [udp-port number] [notification-type] command.
ipv6 access-list -name
(Optional) Enter the keyword ipv6 followed by the IPv6 access list
name (a string up to 16 characters long)
access-list-name ipv6
access-list-name
(Optional) Enter both an IPv4 and IPv6 access list name.
Version 8.3.11.1 Introduced on Z9000
Version 8.3.10.2 Added access parameter support
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
Note: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP, ICMP rules
are not valid for SNMP. In IPv6 ACLs port rules are not valid for SNMP.
Note: The number of configurable groups is limited to 16 groups.
show snmp group
Display the group name, security model, view status, and storage
type of each group.
show running-config snmp Display the SNMP running configuration