Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P

1361

1364 | sFlow

www.dell.com | support.dell.com

Command

History

Usage

Information

This command changes the sampling rate for an Interface. By default, the sampling rate of an

interface is set to the same value as the current global default sampling rate. If the value

entered is not a correct power of 2, the command generates an error message with the

previous and next power-of-2 value. Select one of these two numbers and re-enter the

command.

Commands

show sflow

c e s

Display the current sFlow configuration

Syntax

show sflow [interface]

Parameters

Command Modes

EXEC

EXEC Privilege

Command

History

Version 8.3.7.0 Introduced on S4810

Version 8.2.1.0 Introduces on S-Series Stacking

Version 8.1.1.0 Introduced on E-Series ExaScale

Version 7.7.1.0 Introduced on S-Series

Version 7.6.1.0 Introduced on C-Series

Version 6.2.1.1 Introduced on E-Series

sflow sample-rate (Global) Change the sampling rate globally.

interface

(OPTIONAL) Enter the following keywords and slot/port or number information:

• For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet

followed by the slot/port information.

• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed

by the slot/port information.

• For a Loopback interface, enter the keyword loopback followed by a number

from 0 to 16383.

• For a SONET interface, enter the keyword sonet followed by the slot/port

information.

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet