Reference Guide

1286 | Security
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use the enable password command to define a password for the level to which you are
assigning privilege or access.
privilege level (LINE mode)
c e s
Change the access level for users on the terminal lines.
Syntax
privilege level
level
To delete access to a terminal line, use the no privilege level level command.
Parameters
Defaults
level = 15
Command Modes
LINE
mode
Enter one of the following keywords as the mode for which you are controlling
access:
•
configure for the CONFIGURATION mode
• exec for the EXEC mode
• interface for the INTERFACE modes
•
line for the LINE mode
• route-map for the ROUTE-MAP
• router for the ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER
BGP modes.
level level Enter the keyword level followed by a number for the access level.
Range: 0 to 15.
Level 1 is the EXEC mode and Level 15 allows access to all CLI modes and
commands.
reset
Enter the keyword reset to return the security level to the default setting.
command
Enter the command’s keywords to assign the command to a certain access level.
You can enter one or all of the keywords
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
level level Enter the keyword level followed by a number for the access level.
Range: 0 to 15.
Level 1 is the EXEC mode and Level 15 allows access to all CLI modes.