Reference Guide

1246 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
Although the passive interface will neither send nor receive routing updates, the network on
that interface will still be included in RIP updates sent via other interfaces.
Related
Commands
redistribute
c e s
Redistribute information from other routing instances.
Syntax
redistribute {connected | static}
To disable redistribution, use the
no redistribute {connected | static} command.
Parameters
Defaults
Not configured.
interface
Enter the following information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
neighbor Enable RIP for a specified network.
network Define a neighbor.
connected
Enter the keyword connected to specify that information from active routes on
interfaces is redistributed.
static
Enter the keyword static to specify that information from static routes is
redistributed.