Reference Guide

1146 | Port Monitoring
www.dell.com | support.dell.com
Syntax
show config
Defaults
No default values or behavior
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Example
FTOS(conf-mon-sess-11)#show config
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet 10/47 direction rx
FTOS#
show monitor session
c e s
Display the monitor information of a particular session or all sessions.
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session command.
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS#show monitor session 11
SessionID Source Destination Direction Mode
--------- ------ ------------- --------- -------
11 Gi 10/0 Gi 10/47 rx interface
Related
Commands
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
session-ID
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
monitor session Create a session for monitoring.