Reference Guide

1136 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Syntax
ipv6 pim rp-address address group-address group-address mask override
To remove an RP address, use the no ipv6 pim re-address address group-address mask
override.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Usage
Information
The RP addresses are stored in the order in which they are entered. RP addresses learnt via
BSR take priority over static RP addresses.
Without the override option, RPs advertised by the BSR updates take precedence over the
statically configured RPs.
ipv6 pim rp-candidate
e
Specify an interface as an RP candidate.
Syntax
ipv6 pim rp-candidate interface [priority-value]
address
Enter the IPv6 RP address in the x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zero.
group-address
group-address mask
Enter the keyword group-address followed by the group address in
the x:x:x:x::x format and then the mask in /nn format to assign that
group address to the RP.
The :: notation specifies successive hexadecimal fields of zero.
override
Enter the keyword override to override the BSR updates with static
RP. The override will take effect immediately during enable/disable.
Note: This option is applicable to multicast group range.
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced