Reference Guide

PIM-Sparse Mode (PIM-SM) | 1133
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Command
History
ipv6 pim dr-priority
e
Change the Designated Router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
Defaults
1
Command Modes
INTERFACE
Command
History
Usage
Information
The router with the largest value assigned to an interface becomes the Designated Router. If
two interfaces contain the same DR priority value, the interface with the largest interface IP
address becomes the Designated Router.
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to
4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length for RP selection.
Range: 0 to 128
Default: 126
priority
(OPTIONAL) Enter the priority value for Bootstrap election process.
Range: 0 to 255
Default: 0
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
priority-value Enter a number. Preference is given to larger/higher number.
Range: 0 to 4294967294
Default: 1
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced