Reference Guide

PIM-Sparse Mode (PIM-SM) | 1113
ip pim join-filter
c e s
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list.
This command prevents the PIM SM router from creating state based on multicast source
and/or group.
Syntax
ip pim join-filter
ext-access-list {in | out}
Remove the access list using the command
no ip pim join-filter ext-access-list {in | out}
Parameters
Defaults
None
Command Modes
INTERFACE
Command
History
Example
FTOS(conf)# ip access-list extended iptv-channels
FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24
FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related
Commands
ip pim ingress-interface-map
c e s
When the Dell Force10 system is the RP, statically map potential incoming interfaces to (*,G)
entries to create a lossless multicast forwarding environment.
Syntax
ip pim ingress-interface-map
std-access-list
Parameters
Defaults
None
Command Modes
INTERFACE
ext-access-list Enter the name of an extended access list.
in
Enter this keyword to apply the access list to inbound traffic.
out
Enter this keyword to apply the access list to outbound traffic.
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on C-Series on port-channels and S-Series
Version 7.7.1.0 Introduced on E-Series.
ip access-list
extended
Configure an access list based on IP addresses or protocols.
std-access-list Enter the name of an standard access list that permits the