Reference Guide

102 | Control and Monitoring
www.dell.com | support.dell.com
Syntax
show cpu-traffic-stats [port number | all | cp | linecard {all | slot# } | rp1 | rp2 ]
Parameters
Defaults
all
Command Modes
EXEC
Command
History
Example
(E-Series)
FTOS#show cpu-traffic-stats
Processor : CP
--------------
Received 100% traffic on GigabitEthernet 8/2 Total packets:100
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
Processor : RP1
---------------
Received 62% traffic on GigabitEthernet 8/2 Total packets:500
LLC:0, SNAP:0, IP:500, ARP:0, other:0
Unicast:500, Multicast:0, Broadcast:0
Received 37% traffic on GigabitEthernet 8/1 Total packets:300
LLC:0, SNAP:0, IP:300, ARP:0, other:0
Unicast:300, Multicast:0, Broadcast:0
Processor : RP2
---------------
No CPU traffic statistics.
FTOS#
port number (OPTIONAL) Enter the port number to display traffic statistics on that port
only.
Range: 1 to 1568
all
(OPTIONAL) Enter the keyword all to display traffic statistics on all the
interfaces receiving traffic, sorted based on traffic.
cp
(OPTIONAL) Enter the keyword cp to display traffic statistics on the
specified CPU.
Note: This option is supported on E-Series only.
linecard
(OPTIONAL) Enter the keyword linecard followed by either all or the slot
number to display traffic statistics on the designated line card.
Note: This option is supported on C-Series only.
rp1
(OPTIONAL) Enter the keyword rp1 to display traffic statistics on the RP1.
Note: This option is supported on E-Series only.
rp2
(OPTIONAL) Enter the keyword rp2 to display traffic statistics on the RP2.
Note: This option is supported on E-Series only.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series