Reference Guide

1006 | Multicast
www.dell.com | support.dell.com
To revert to the default, enter no ip multicast-lag-hashing.
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
By default, one Port Channel member is chosen to forward multicast traffic. With this feature
turned on, multicast traffic will be distributed among the Port Channel members in a
round-robin fashion. This feature applies to the routed multicast traffic. If IGMP Snooping is
turned on, this feature also applies to switched multicast traffic.
Related
Commands
ip multicast-limit
c e s
Use this feature to limit the number of multicast entries on the system.
Syntax
ip multicast-limit limit
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Command
History
Usage
Information
This features allows the user to limit the number of multicast entries on the system. This
number is the sum total of all the multicast entries on all line cards in the system. On each line
card, the multicast module will only install the maximum possible number of entries,
depending on the configured CAM profile.
Version 6.3.1.0 Introduced for E-Series
ip multicast-limit Enable IP multicast forwarding.
limit
Enter the desired maximum number of multicast entries on the system.
E-Series Range: 1 to 50000
E-Series Default: 15000
C-Series Range: 1 to 10000
C-Series Default: 4000
S-Series Range: 1 to 2000
S-Series Default: 400
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series