Users Guide

CONFIGURATION mode
redundancy auto-failover-limit
• Re-Enable the auto-failover-limit with its default parameters.
CONFIGURATION mode
redundancy auto-failover-limit
(no parameters)
Disabling Auto-Reboot
To disable auto-reboot, use the following command.
• Prevent a failed stack unit from rebooting after a failover.
CONFIGURATION mode
redundancy disable-auto-reboot
Manually Synchronizing Management and Standby Units
To manually synchronize Management and Standby units at any time, use the following command.
• Manually synchronize Management and Standby units.
EXEC Privilege mode
redundancy synchronize full
Pre-Conguring a Stack Unit Slot
You may also pre-congure an empty stack unit slot with a logical stack unit.
To pre-congure an empty stack unit slot, use the following command.
• Pre-congure an empty stack unit slot with a logical stack unit.
CONFIGURATION mode
stack-unit unit_id provision S4810
Example of Viewing a Logical Conguration of a Pre-Congured Stack Unit
After creating the logical stack unit, you can congure the interfaces on the stack unit as if it is present.
Dell#show system stack-unit 1
-- Unit 1 --
Unit Type : Member Unit
Status : not present
Dell#con
Dell(conf)#stack-unit 1 provision S4810
Dell(conf)#end
Dell#show system stack-unit 1
-- Unit 1 --
Unit Type : Member Unit
Status : not present
Required Type : S4810 - 52-port GE/TE/FG (SE)
Dell#
High Availability (HA)
341