Reference Guide

56 | Management
www.dell.com | support.dell.com
null Null interface
port-channel Port-channel interface
range Configure interface range
sonet SONET interface
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN interface
FTOS(conf)#interface gigabitethernet 1/1
FTOS(conf-if-gi-1/1)#?
end Exit from configuration mode
exit Exit from interface configuration mode
FTOS(conf-if-gi-1/1)#exit
FTOS(conf)#line ?
aux Auxiliary line
console Primary terminal line
vty Virtual terminal
FTOS(conf)#line vty 0
FTOS(config-line-vty)#?
exit Exit from line configuration mode
FTOS(config-line-vty)#
Apply a Privilege Level to a Username
To set a privilege level for a user:
Apply a Privilege Level to a Terminal Line
To set a privilege level for a terminal line:
Configure Logging
FTOS tracks changes in the system using event and error messages. By default, FTOS logs these messages
on:
• the internal buffer
• console and terminal lines, and
• any configured syslog servers
Disable Logging
Task Command Syntax Command Mode
Configure a privilege level for a user.
username username privilege level
CONFIGURATION
Task Command Syntax Command Mode
Configure a privilege level for a terminal line.
privilege level level
LINE
Note: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode,
but the prompt is hostname#, rather than hostname>.