Reference Guide

iSCSI Optimization | 483
Displaying iSCSI Optimization Information
Use the show commands in Table 23-53 to display information on iSCSI optimization
Figure 23-41. show iscsi Command Example
12 (Optional) Enter interface configuration mode to
configure the auto-detection of Compellent disk
arrays.
interface port-type slot/port CONFIGURATION
13 (Optional) Configures the auto-detection of
Compellent arrays on a port.
Default: Compellent disk arrays are not detected.
[no] iscsi profile-compellent
INTERFACE
Table 23-53. Displaying iSCSI Optimization Information
Command Output
show iscsi (Figure 23-41) Displays the currently configured iSCSI settings.
show iscsi sessions (Figure 23-42) Displays information on active iSCSI sessions on the switch.
show iscsi sessions detailed [session isid]
(Figure 23-43)
Displays detailed information on active iSCSI sessions on the switch. To
display detailed information on specified iSCSi session, enter the session’s
iSCSi ID.
show run iscsi Displays all globally-configured non-default iSCSI settings in the current
FTOS session.
Step Task Command Command Mode
FTOS#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860