Reference Guide

460 | IPv4 Routing
www.dell.com | support.dell.com
To view the configured static routes for the management port, use the show ip management-route command
in the EXEC privilege mode.
FTOS#show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
S 2.1.2.0/24 Direct, Nu 0 0/0 00:02:30
S 6.1.2.0/24 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.2/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.3/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.4/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.5/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.6/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.7/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.8/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.9/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.10/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.11/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.12/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.13/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.14/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.15/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.16/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 6.1.2.17/32 via 6.1.20.2, Te 5/0 1/0 00:02:30
S 11.1.1.0/24 Direct, Nu 0 0/0 00:02:30
Direct, Lo 0
--More--
Directed Broadcast
By default, FTOS drops directed broadcast packets destined for an interface. This default setting provides
some protection against Denial of Service (DOS) attacks.
To enable FTOS to receive directed broadcasts, use the following command in the INTERFACE mode:
To view the configuration, use the
show config command in the INTERFACE mode.
Resolution of Host Names
Domain Name Service (DNS) maps host names to IP addresses. This feature simplifies such commands as
Telnet and FTP by allowing you to enter a name instead of an IP address.
Dynamic resolution of host names is disabled by default. Unless the feature is enabled, the system resolves
only host names entered into the host table with the
ip host command.
• Enable dynamic resolution of host names
Command Syntax Command Mode Purpose
ip directed-broadcast
INTERFACE Enable directed broadcast.