Reference Guide

Content Addressable Memory (CAM) | 257
You can re-configure the amount of space allocated for each type of entry. FTOS requires that you specify
an amount of CAM space for all types and in the order shown in Table 11-22.
• The IPv4Flow configuration is applied to entire system when you enter the command
cam-ipv4flow
from CONFIGURATION mode, however, you must save the running-configuration to affect the
change.
The amount of space that is allocated among the sub-partitions must be equal to the amount of CAM space
allocated to IPv4Flowby the selected CAM profile (refer to Table 11-18.); Message 7 is displayed if the
total allocated space is not correct.
The minimum amount of space that can be allocated to any sub-partition is 1K, except for System flow, for
which the minimum is 4K.
To re-allocate CAM space within the IPv4Flow partition on the entire system:
FTOS(conf)#cam-ipv4flow default
FTOS#copy running-config startup-config
File with same name already exist.
Proceed to copy the file [confirm yes/no]: yes
!
3914 bytes successfully copied
FTOS#sh cam-ipv4flow
-- Chassis Cam Ipv4Flow --
PBR 1K 1K 1K
QoS 8K 2K 2K
System Flow 5K 5K 5K
Trace Lists 1 1K 1K
Message 7 IPv4Flow Configuration Error
% Error: Total size must add up to match IPv4flow size of 24K required by the configured profile.
Step Task Command Syntax Command Mode
1 Re-allocate CAM space within the
IPv4Flow partition.
cam-ipv4flow
CONFIGURATION
2 Save the running-configuration.
copy running-config startup-config
EXEC Privilege
3 Verify that the new CAM configuration will
be written to the CAM on the next boot.
show cam-ipv4flow
EXEC Privilege
4 Reload the system.
reload
EXEC Privilege
Table 11-22. IPv4Flow CAM Sub-partition Sizes
Partition
Space Allocated
(EtherScale)
Space Allocated
(TeraScale)
Space Allocated
(ExaScale)