Reference Guide

194 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
For address family: IPv4 Unicast
BGP neighbor is zanzibar, peer-group internal,
Number of peers in this group 26
Peer-group members (* - outbound optimized):
10.68.160.1
10.68.161.1
10.68.162.1
10.68.163.1
10.68.164.1
10.68.165.1
10.68.166.1
10.68.167.1
10.68.168.1
10.68.169.1
10.68.170.1
10.68.171.1
10.68.172.1
10.68.173.1
10.68.174.1
10.68.175.1
10.68.176.1
10.68.177.1
10.68.178.1
10.68.179.1
10.68.180.1
10.68.181.1
10.68.182.1
10.68.183.1
10.68.184.1
10.68.185.1
FTOS>
BGP fast fall-over
By default, a BGP session is governed by the hold time. BGP routers typically carry large routing tables, so
frequent session resets are not desirable. The BGP fast fall-over feature reduces the convergence time
while maintaining stability. The connection to a BGP peer is immediately reset if a link to a directly
connected external peer fails.
When fall-over is enabled, BGP tracks IP reachability to the peer remote address and the peer local
address. Whenever either address becomes unreachable (for example, no active route exists in the routing
table for peer IPv6 destinations/local address), BGP brings down the session with the peer.
The BGP fast fall-over feature is configured on a per-neighbor or peer-group basis and is disabled by
default.
To disable Fast Fall-Over, use the
[no] neighbor [neighbor | peer-group] fall-over command in
CONFIGURATION ROUTER BGP mode
Command Syntax Command Mode Purpose
neighbor {ip-address |
peer-group-name} fall-over
CONFIG-ROUTER-BGP Enable BGP Fast Fall-Over