Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4810–ON Installation Guide August 2020
- About this Guide
- The S4810–ON System
- Site preparations
- Install the S4810–ON
- Power supplies
- Fans
- Console Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Removing the SD card
- Replacing the battery
- Technical support
Figure 3. S4810–ON LEDs
1. SYS
2. MASTER
3. FAN
4. PSU
FAN LEDs
The top fan LED is FAN-1 LED; the bottom fan LED is FAN-0 LED.
LED Behavior on the S4810–ON System
The following S4810–ON system LED behavior is seen during U-Boot and ONIE operations.
Table 1. S4810–ON LED Behavior
LED Description
System Status LED
• Off — no power
• Blinking green — booting or system is in Diagnostic mode
• Solid green — normal operation
• Solid red — critical alarm
• Blinking red — non-critical alarm
Master LED
• Solid green — system is in Stacking Master mode
• Off — System is in Slave mode
Fan LED
• Solid green — Fan is powered on and running at the expected
RPM
The S4810–ON System 9