Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4810–ON Installation Guide August 2020
- About this Guide
- The S4810–ON System
- Site preparations
- Install the S4810–ON
- Power supplies
- Fans
- Console Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Removing the SD card
- Replacing the battery
- Technical support
Features
The S4810–ON offers the following features.
• S4810–ON CPU and switch processor
• Hot-swappable redundant power supply
• 19 inch rack-mountable
• Standard 1U chassis height
Ports
The S4810–ON offers the following ports.
• External Serial RS-232 port (RJ45 type)
• Remote management port
• 48–ports 10GbE and 4–ports 40GbE
• Universal serial bus (USB)-A port
• USB-B port
System Status
You can view S4810–ON status information using the light emitting diodes (LEDs).
LED Displays
The S4810–ON includes LED displays on the I/O side of the chassis (shown in the following figure).
When the S4810–ON powers up or reloads, the PSU LED is solid green. For additional LED information, see your third-party operating
software documentation.
The S4810–ON system LEDs are:
• System status (SYS)
• Stack Master indicator (MASTER)
• Fan status (FAN)
• Power status (PSU)
Also, the PSUs and fans have LEDs that indicate their individual status:
• PSU status
• Fan tray status
• System
8
The S4810–ON System