Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4810–ON Installation Guide August 2020
- About this Guide
- The S4810–ON System
- Site preparations
- Install the S4810–ON
- Power supplies
- Fans
- Console Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Removing the SD card
- Replacing the battery
- Technical support
The S4810–ON System
The following sections describe the Dell EMC S4810–ON system.
Topics:
• Introduction
• Prerequisite
• Features
• Ports
• System Status
Introduction
The Dell EMC S4810–ON platform is a next-generation switch/router designed to meet the requirements for distributed data center
cores.
It is a one-rack unit (U) chassis that supports 48 ports of 10 GbE small form-factor pluggable plus (SFP+) and four quad small form-factor
pluggable plus (QSFP+) ports. For system access, the S4810–ON includes an RS-232/RJ-45 console port and a management port for
system access.
The S4810–ON I/O (I/O) side contains the 48 ports of 10 GbE and four uplink ports of 40 GbE QSFP+ autosensing ports and
management ports.
Figure 1. S4810–ON I/O-Side View
1. System LEDs
2. RS-232/RJ-45 Console Port
3. Management (Ethernet) Port
4. 40GE QSFP+ Ports
5. 10GE SFP+ Ports
The S4810–ON power supply unit (PSU) side (shown in the following figure) contains the PSU and fan modules.
2
6 The S4810–ON System