Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4810–ON Installation Guide August 2020
- About this Guide
- The S4810–ON System
- Site preparations
- Install the S4810–ON
- Power supplies
- Fans
- Console Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Removing the SD card
- Replacing the battery
- Technical support
1. Disconnect the power cable from the PSU.
2. Use the grab handle to slide the PSU out of the power supply bay.
3. Use the grab handle on the replacement PSU to slide it into the power supply bay.
4. Tighten the securing screws on the replacement PSU with a screwdriver. Ensure that the PSU is secure.
5. Attach the power cable to the replacement PSU.
The system powers up when the cables are connected between the power supply and the power source.
22 Power supplies