Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4810–ON Installation Guide August 2020
- About this Guide
- The S4810–ON System
- Site preparations
- Install the S4810–ON
- Power supplies
- Fans
- Console Ports
- Specifications
- Chassis Physical Design
- Agency Compliance
- USA Federal Communications Commission (FCC) Statement
- European Union EMC Directive Conformance Statement
- Japan: VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic Compatibility (EMC)
- Product Recycling and Disposal
- Removing the SD card
- Replacing the battery
- Technical support
Site preparations
The S4810–ON is suitable for installation as part of a common bond network (CBN).
You can install the system in:
• Network telecommunication facilities
• Data centers
• Other locations where the National Electric Code (NEC) applies.
For more information about S4810–ON specifications, see Specifications.
NOTE: Install the S4810–ON system into a rack or cabinet before installing any optional components.
Topics:
• Site Selection
• Cabinet Placement
• Rack Mounting
• Grounding (Optional)
• Fans and Airflow
• Power
• Storing Components
Site Selection
Install Dell EMC equipment in restricted access areas.
A restricted access area is one where service personnel can only gain access using a special tool, lock, key or other means of security.
Also, access is controlled by the authority responsible for the location.
Ensure that the area where you install your S4810–ON system meets the following safety requirements:
• Near an adequate power source. Connect the system to the appropriate branch circuit protection as defined by your local electrical
codes.
• The environmental temperature is between from 0° to 40°C (32° to 104°F).
• Relative humidity that does not exceed 85 percent noncondensing.
• In a dry, clean, well-ventilated, and temperature-controlled room, away from heat sources such as hot air vents or direct sunlight.
• The equipment is away from sources of severe electromagnetic noise.
• Position equipment in a rack or cabinet, or on a desktop with adequate space in the front, rear, and sides for proper ventilation and
access.
Cabinet Placement
Install the S4810–ON only in indoor cabinets that are designed for use in a controlled environment.
Do not install the S4810–ON in outside plant cabinets. For cabinet placement requirements, see Site Selection.
The cabinet must be a minimum cabinet size. Airflow must be according to the Electronic Industries Alliance (EIA) standard. Ensure that
there is a minimum of 12.7 cm (5 inches) between the intake and exhaust vents and the cabinet wall.
Rack Mounting
When you prepare your equipment rack, ensure that the rack is earth ground.
Ground the equipment rack to the same ground point the power service in your area uses. The ground path must be permanent.
3
Site preparations 11