Setup Guide
Table Of Contents
- Dell EMC PowerSwitch S4200-ON Series Set-up Guide
- About this guide
- Site preparations
- S4200-ON Series Installation
- Unpack
- Rack or cabinet installation
- ReadyRails installation
- 1U Tool-less mount installation
- Two-post flush-mount installation
- Two-post center-mount installation
- Four-post threaded installation
- S4200-ON Series switch installation
- 1U front-rack installation
- Optics installation
- Switch power-up
- After switch installation
- Specifications
- Support
Figure 6. Four-post threaded installation
2. For each rail, attach the front and back flanges to the post flanges with two user-supplied screws at each end.
S4200-ON Series switch installation
For the 1U two-post configurations, slide the switch into the rails in the same manner as the four-post configurations.
1U front-rack installation
Configure the rails that are attached to the switch.
1.
NOTE: For more information, see the installation instruction labels on the rail.
Attach the inner switch rails to the S4200-ON Series switch.
Line up the rail with the mounting heads and attach the rail to the chassis. Slide the rail back until it locks into place. The
following shows the detail of the front standoff with the locking tab:
14
S4200-ON Series Installation