Reference Guide

area encryption
Congures encryption for an OSPFv3 area.
Syntax
area area-id encryption ipsec spi number esp encryption-type key
authentication-type key
Parameters
• area area-id — Enter an area ID as a number or IPv6 prex.
• ipsec spi number — Enter a unique security policy index number (256 to 4294967295).
• esp encryption-type — Enter the encryption algorithm used with ESP (3DES, DES, AES-CBC, or
NULL). For AES-CBC, only the AES-128 and AES-192 ciphers are supported.
• key — Enter the text string used in the encryption algorithm.
• authentication-type — Enter the encryption authentication algorithm to use (MD5 or SHA1).
• key — Enter the text string used in the authentication algorithm.
Default OSPFv3 area encryption is not congured.
Command Mode ROUTER-OSPFv3
Usage Information
• Before you enable IPsec encryption for an OSPFv3 area, you must enable OSPFv3 globally on each router.
• When you congure encryption at the area level, both IPsec encryption and authentication are enabled. You
cannot congure encryption if you have already congured an IPsec area authentication (area ospf
authentication ipsec). To congure encryption, you must rst delete the authentication policy.
• All OSPFv3 routers in the area must share the same encryption key to decrypt information. Only a non-
encrypted key is supported. Required lengths of the non-encrypted key are: 3DES — 48 hex digits; DES — 16
hex digits; AES-CBC — 32 hex digits for AES-128 and 48 hex digits for AES-192.
• All OSPFv3 routers in the area must share the same authentication key to exchange information. Only a non-
encrypted key is supported. For MD5 authentication, the non-encrypted key must be 32 plain hex digits. For
SHA-1 authentication, the non-encrypted key must be 40 hex digits. An encrypted key is not supported.
Example
OS10(config-router-ospfv3-100)# area 1 encryption ipsec spi 401 esp des
1234567812345678 md5
12345678123456781234567812345678
Supported Releases 10.4.0E(R1) or later
area stub
Denes an area as the OSPF stub area.
Syntax
area area-id stub [no-summary]
Parameters
• area-id—Set the OSPFv3 area ID as an IP address (A.B.C.D) or number (1 to 65535).
• no-summary—(Optional) Prevents an area border router from sending summary link advertisements into the
stub area.
Default Not congured
Command Mode ROUTER-OSPFv3
Usage Information The no version of this command deletes a stub area.
Example
OS10(config)# router ospfv3 10
OS10(conf-router-ospfv3-10)# area 10.10.1.5 stub
382 Layer 3