Reference Guide

-- Unit 1 --
Status : up
System Identifier : 1
Down Reason :
System Location LED : off
Required Type : S4048
Current Type : S4048
Hardware Revision :
Software Version : 10.3.9999E(X)
Physical Ports : 48x10GbE, 6x40GbE
BIOS : 3.21.0.4
System CPLD : 15
Master CPLD : 12
Slave CPLD : 5
-- Power Supplies --
PSU-ID Status Type AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 fail
2 up AC REVERSE 1 14720 up
-- Fan Status --
FanTray Status AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up REVERSE 1 13063 up
2 13063 up
2 up REVERSE 1 13020 up
2 12977 up
3 up NORMAL 1 13085 up
2 13063 up
Candidate conguration
When you enter OS10 conguration commands in the transaction-based conguration mode, changes do not take eect immediately and
are stored in the candidate conguration. The conguration changes become active on the network device only after you commit the
changes with the commit command. Changes in the candidate conguration are validated and applied to the running conguration.
The candidate conguration allows you to avoid introducing errors during an OS10 conguration session. You can make changes and then
check them before committing them to the active, running conguration on the network device.
Use the show diff command to check dierences between the running conguration and the candidate conguration. After comparing
the two, you can decide if you would like to commit the changes to the running conguration. Use the discard command to delete
uncommitted changes.
• Enter show ? from EXEC mode to view a list of commands to monitor a device.
OS10# show ?
aaa Current candidate aaa configuration
access-list Current candidate access-list configuration
as-path Current candidate as-path configuration
bgp Current candidate bgp configuration
class-map Current candidate class-map configuration
community-list Current candidate community-list configuration
compressed Current candidate configuration in compressed format
control-plane Current candidate control-plane configuration
dot1x Current candidate dot1x configuration
extcommunity-list Current candidate extcommunity-list configuration
interface Current candidate interface configuration
lacp Current candidate lacp configuration
lldp Current candidate lldp configuration
logging Current candidate logging configuration
monitor Current candidate monitor session configuration
Getting Started
33