Reference Guide

===================================================================================
Ethernet 1/1/1:1 up / up fe80::eef4:bbff:fefb:f9f0/64
2017::1/64 Enabled
Ethernet 1/1/20 up / up fe80::eef4:bbff:fefb:fa30/64
2020::1/64 Enabled
Management 1/1/1 up / up fe80::eef4:bbff:fefb:f9ef/64 Enabled
Vlan 1 up / up fe80::eef4:bbff:fefb:fa59/64 Enabled
IPv6 addresses
An IPv6 address consists of a 48-bit global routing prex, optional 16-bit subnet ID, and a 64-bit interface identier in the extended
universal identier (EUI)-64 format.
IPv6 128-bit addresses are represented as a series of eight 16-bit hexadecimal elds separated by colons: x:x:x:x:x:x:x:x.
2001:0db8:0000:0000:0000:0000:1428:57a
Leading zeros in each eld are optional. You can also use two colons (::) to represent successive hexadecimal elds of zeros, but you can
use this short version only once in each address:
2001:db8::1428:57ab
In the following example, all the addresses are valid and equivalent:
• 2001:0db8:0000:0000:0000:0000:1428:57ab
• 2001:0db8:0000:0000:0000::1428:57ab
• 2001:0db8:0:0:0:0:1428:57ab
• 2001:0db8:0:0::1428:57ab
• 2001:0db8::1428:57ab
• 2001:db8::1428:57ab
IPv6 networks are written using CIDR notation. An IPv6 network (or subnet) is a contiguous group of IPv6 addresses the size of which
must be a power of two. The initial bits of addresses, which are identical for all hosts in the network, are the network's prex.
A network is denoted by the rst address in the network and the size in bits of the prex (in decimal), separated with a slash. Because a
single host is seen as a network with a 128-bit prex, host addresses may be written with a following /128.
For example, 2001:0db8:1234::/48 stands for the network with addresses 2001:0db8:1234:0000:0000:0000:0000:0000
through 2001:0db8:1234:ffff:ffff:ffff:ffff:ffff.
As soon as an IPv6 address is assigned, IPv6 packet processing is enabled on an interface. You can manually disable and re-enable IPv6
processing on an interface congured with an IPv6 address using the no ipv6 enable and ipv6 enable commands.
To remove all IPv6 addresses from an interface, use the no ipv6 address command. To remove a specic IPv6 address, use the ipv6
address ipv6-address/mask command.
Link-local addresses
When an OS10 switch boots up, an IPv6 unicast link-local address is automatically assigned to an interface using stateless conguration. A
link-local address allows IPv6 devices on a local link to communicate without requiring a globally unique address. IPv6 reserves the address
block FE80::/10 for link-local unicast addressing.
Global addresses
To enable stateless autoconguration of an IPv6 global address and set the interface to Host mode, use the ipv6 address
autoconfig command. The router receives network prexes in IPv6 router advertisements (RAs). An interface ID is appended to the
prex. In Host mode, IPv6 forwarding is disabled.
Layer 3
313