Reference Guide

force-authorized
(default)
This is an authorized state. A device connected to this port does not use the authentication process but can
communicate on the network. Placing the port in this state is same as disabling 802.1X on the port. force-
authorized is the default mode.
force-unauthorized This is an unauthorized state. A device connected to a port does not use the authentication process but is not
allowed to communicate on the network. Placing the port in this state is the same as shutting down the port. Any
attempt by the supplicant to initiate authentication is ignored.
auto This is an unauthorized state by default. A device connected to this port is subject to the authentication process. If
the process is successful, the port is authorized and the connected device communicates on the network.
• Place a port in the Auto, Force-authorized (default), or Force-unauthorized state in INTERFACE mode.
dot1x port-control {auto | force-authorized | force-unauthorized}
Congure and verify force-authorized state
OS10(conf-range-eth1/1/7-1/1/8)# dot1x port-control force-authorized
OS10(conf-range-eth1/1/7-1/1/8)# do show dot1x interface ethernet 1/1/7
802.1x information on ethernet1/1/7
-------------------------------------
Dot1x Status: Enable
Port Control: AUTHORIZED
Port Auth Status: UNAUTHORIZED
Re-Authentication: Enable
Tx Period: 120 seconds
Quiet Period: 120 seconds
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 5
Host Mode: MULTI_HOST
Auth PAE State: Initialize
Backend State: Initialize
View interface running conguration
OS10(conf-range-eth1/1/7-1/1/8)# do show running-configuration interface
...
!
interface ethernet1/1/7
no shutdown
dot1x max-req 5
dot1x re-authentication
dot1x timeout quiet-period 120
dot1x timeout tx-period 120
!
interface ethernet1/1/8
no shutdown
dot1x max-req 5
dot1x re-authentication
dot1x timeout quiet-period 120
dot1x timeout tx-period 120
...
Reauthenticate port
Congures the time period for reauthentication. After the supplicant is authenticated and the port is authorized, congure the
authenticator to reauthenticate the supplicant. If you enable reauthentication, the supplicant reauthenticates every 3600 seconds.
• Re-authenticate the supplicant in INTERFACE mode (1 to 65535, default 3600).
dot1x timeout re-authperiod seconds
Layer 2
145