Deployment Guide
Table Of Contents
- 1 Introduction
- 2 Hardware overview
- 3 Topology overview
- 4 Preparation
- 5 S4148U-ON switch configuration
- 6 S4148U-ON validation
- 7 Configure Unity FC storage
- 8 Configure storage on ESXi hosts
- 9 Configure ESXi hosts for LAN traffic
- A Validated components
- B Technical support and resources
- C Support and feedback
57 Dell EMC Networking FCoE-to-Fibre Channel Deployment with S4148U-ON in F_port Mode | version 1.0
9.7 Verify connectivity to the production network
Log in to a guest OS by right-clicking on the VM and selecting Open Console. Use the procedure dictated by
the guest OS to configure an IP address and default gateway on the newly added vNIC.
VMs in this deployment have IP addresses on the 172.16.1.0/24 network. The default gateway is the VRRP
IP address configured on the S4148U-ON leaf switches, 172.16.1.254.
Test connectivity by pinging the default gateway and other configured VMs in the rack. If spines, leaf
switches, and hosts in other racks are configured per
Dell EMC Networking Layer 3 Leaf-Spine Deployment
and Best Practices with OS10, pings will also succeed over the leaf-spine network.
Note: Guest operating system firewalls may need to be temporarily disabled or modified to allow responses
to ICMP ping requests.